Ats Handheld Inductive Loop Tester HILT 9000 Manuel d'utilisateur télécharger pdf (Page 10)

9

HILT 9000 - Inductive Loop Tester

Function Controls Summary

BUTTON DESCRIPTION COMMENTS

LOOP Used to measure L, Q, and R

DC

of the loop. Q is measured up

to 15. If Q>15, use Q button to

obtain the actual value of Q

The loop must be

disconnected from the

system to run this test

Q Used to measure high Q

values (when Q is >15)

The loop must be

disconnected from the

system to run this test

∆L

Used to measure change of

inductance

The loop must be

disconnected from the

system to run this test

DETECTOR Used to measure operating

parameters of the loop

system: V

P-P

, Oscillating

Frequency, and Mode

The loop must be

connected from the

system to run this test

SET FREQ. Used to select operating

frequency to measure L and Q

! and "

Used in SET FREQ mode to

increase and decrease

frequency in 1KHz steps.

POWER Used to turn the unit on and

off.

The tester can be

turned off at any time

during or after a test

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17

Commentaires sur ces manuels

Pas de commentaire